Re: Is there single step debugging support being added to aarch64-linux?

[Prafull Suryawanshi <prafull.net@gmail.com>]

I debugged this one and found that when compared to gdb-arm,
gdb-aarch64 behaves little different.
Before even invoking software-single-step operations, gdb-arm invokes
Z0 packet before getting registers.
But gdb-aarch64 does not do it. It sets the Z0 after reading registers.
So in case gdb-arm, the Z0 is set to next pc value.
But for gdb-aarch64 it sets the Z0 at current pc only.

Below is logs when enabled remote_debug option.
for gdb-arm
infrun: resume (step=1, signal=GDB_SIGNAL_0), trap_expected=1, current
thread [Thread 2229] at 0xc01b2ddc
Sending packet: $Z0,c01b2de0,4#67...Ack


For gdb-aarch64,
infrun: resume (step=1, signal=GDB_SIGNAL_0), trap_expected=1, current
thread [Thread 3462] at 0xffffffc00021014c

On Mon, Jun 15, 2015 at 6:21 PM, Yao Qi <qiyaoltc@gmail.com> wrote:
> Prafull Suryawanshi <prafull.net@gmail.com> writes:
>
>> I am not sure why hw stepper not works here (might be limitation of hw
>> I am using).
>
> You'd better to check whether hw single step doesn't work in your case.
>
>> That is may be the infrun loops as it never gets stop signal. (the
>> output I earlier pasted).
>> Is it ok to provide patch for software single step like arm here?
>
> We only implement software single step on the targets don't have
> hardware single step capability, like arm.
>
>> (I am preparing one. It will have simulate aarch64 instruction set and
>> implement aarch64 version of functions of
>> arm_linux_software_single_step, arm_insert_single_step_breakpoint and
>> arm_get_next_pc.)
>
> Before you start it, better to get the reason why hw single step doesn't
> work on aarch64.
>
> --
> Yao (齐尧)