Re: [RFA] 32/64 mistake in mips_find_saved_regs

[Michael Snyder <msnyder@redhat.com>]

Andrew Cagney wrote:
> 
> I believe n32 should be setting mips64 to 1.  Can you please change that. .

Really?  So you think mips64 specifies 64-bit registers, rather than
64 bit addresses?  I'll try the change, and see what happens.

> As for the below, yes ok.  Can you please also update the comment to
> read something like:
> 
> ``[Apparently] The freg_offset gives the offset to the first 64 bit saved.
> 
> When the ABI specifies 64 bit saved registers, the FREG_OFFSET
> designates the first saved 64 bit register.
> 
> When the ABI specifies 32 bit saved registers, the ``64 bit saved
> DOUBLE'' consists of two adjacent 32 bit registers,  Hence FREG_OFFSET,
> designates the address of the lower register of the register pair.
> Adjust the offset so that it designates the upper register of the pair
> -- i.e., the address of the first saved 32 bit register.''
> 
> I think that is more correct.

Will do.

> 
> Andrew
> 
> > Here is a test that should check for stack/register size, not
> > whether target == mips64.
> >
> > Fixes four failures in callfuncs.exp, no other regressions.
> >
> >
> >
> > 2002-08-05  Michael Snyder  <msnyder@redhat.com>
> >
> >       *  mips-tdep.c (mips_find_saved_regs): Adjust stack according
> >       to MIPS_SAVED_REGSIZE, not GDB_TARGET_IS_MIPS64.  N32 is not
> >       MIPS64, but it does save 64 bits worth of register.
> >
> > Index: mips-tdep.c
> > ===================================================================
> > RCS file: /cvs/src/src/gdb/mips-tdep.c,v
> > retrieving revision 1.88
> > diff -p -r1.88 mips-tdep.c
> > *** mips-tdep.c       1 Aug 2002 23:10:34 -0000       1.88
> > --- mips-tdep.c       6 Aug 2002 04:32:33 -0000
> > *************** mips_find_saved_regs (struct frame_info
> > *** 1371,1379 ****
> >        were saved.  */
> >     reg_position = fci->frame + PROC_FREG_OFFSET (proc_desc);
> >
> > !   /* The freg_offset points to where the first *double* register
> > !      is saved.  So skip to the high-order word. */
> > !   if (!GDB_TARGET_IS_MIPS64)
> >       reg_position += MIPS_SAVED_REGSIZE;
> >
> >     /* Fill in the offsets for the float registers which float_mask says
> > --- 1371,1379 ----
> >        were saved.  */
> >     reg_position = fci->frame + PROC_FREG_OFFSET (proc_desc);
> >
> > !   /* The freg_offset points to where the first *double* register is
> > !      saved.  So skip to the high-order word if saved_reg_size == 4. */
> > !   if (MIPS_SAVED_REGSIZE == 4)
> >       reg_position += MIPS_SAVED_REGSIZE;
> >
> >     /* Fill in the offsets for the float registers which float_mask says