[ltt-dev] Newibie questions: How to run LTT

[ali.akyurek.ext@siemens.com (Akyurek, Ali (EXT))]

 
Hi, Could you please try this one:

mount -t relayfs relayfs /mnt/relay


-----Urspr?ngliche Nachricht-----
Von: Bizhan Gholikhamseh (bgholikh) [mailto:bgholikh at cisco.com] 
Gesendet: Dienstag, 23. Dezember 2008 19:30
An: Akyurek, Ali (EXT)
Cc: ltt-dev at lists.casi.polymtl.ca
Betreff: RE: [ltt-dev] Newibie questions: How to run LTT

HI,
Yes, but I get the following error:

CTS:>mount -t relayfs nodev /mnt/relayfs
mount: Mounting nodev on /mnt/relayfs failed: No such device


> -----Original Message-----
> From: Akyurek, Ali (EXT) [mailto:ali.akyurek.ext@siemens.com]
> Sent: Tuesday, December 23, 2008 10:24 AM
> To: Bizhan Gholikhamseh (bgholikh)
> Subject: AW: [ltt-dev] Newibie questions: How to run LTT
> 
> Hi, is CONFIG_RELAYFS_FS enabled in kernel configuration?
> 
> ________________________________
> 
> Von: Bizhan Gholikhamseh (bgholikh) [mailto:bgholikh at cisco.com]
> Gesendet: Dienstag, 23. Dezember 2008 19:13
> An: ltt-dev at lists.casi.polymtl.ca
> Betreff: [ltt-dev] Newibie questions: How to run LTT
> 
> 
> 
> Hi All,
> 
> I finally got some patch to apply to the 2.6.11 (Legcy software) to
enable
> the LTT (older version) on our embedded system.
> 
> Reading documentation it say the first thing I need to do is:
> 
> mkdir /mnt/relayfs
> 
> mount -t relayfs nodev /mnt/redlayfs.
> 
> 
> 
> It fails, is there any better documentation on what to do with this
older
> verison please?
> 
> 
> 
> Thanks,
> 
> B.