Re: Jeeni & ARM720T with GDB

Fernando Nasser
2000-11-20T08:48:00Z

The sequence of commands you should use is:

file <exec>
target rdi e=....
load
break <somewhere>
cont

Don't use the load command argument.

Fernando

danish iftikhar wrote:
>
> Hi
> I am trying to use Jeeni EMbedded Ice to connect from my linux host
> running GDB to Cirrus Logic EP7211 board .
> The board uses ARM720T processor , due to which i have set the same
> configuration in Jeeni .
> Then i tried to connect to target by using target rdi e=IP_ADDR ;
> ( as i tried using ethernet interface ) . It then said connected to target
> ..something..something .
> But when i give the load (filename) , it does'nt do anything ..
> once it said "you can't do that when your target is exec" , i gave the
> target rdi command again and tried to download & then it hanged .
>
> Can anybody explain what is happening...do i need to do anything else for
> downloading the program .
>
> PS: i have set the appropriate endianness also .
>
> regards
> danish.
>
> _________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com .
>
> Share information about yourself, create your own public profile at
> http://profiles.msn.com .

--
Fernando Nasser
Red Hat Canada Ltd. E-Mail: fnasser@redhat.com
2323 Yonge Street, Suite #300
Toronto, Ontario M4P 2C9
From mleibowi@crystal.cirrus.com Mon Nov 20 09:01:00 2000
From: Michael Leibowitz <mleibowi@crystal.cirrus.com>
To: Fernando Nasser <fnasser@cygnus.com>
Cc: danish iftikhar <d_iftikhar@hotmail.com>, gdb@sourceware.cygnus.com
Subject: Re: Jeeni & ARM720T with GDB
Date: Mon, 20 Nov 2000 09:01:00 -0000
Message-id: <20001120110414.B23797@spanky>
References: <F262O6hm8Ua8d9Ee4za00002d74@hotmail.com> <3A1955CE.2A4280C8@cygnus.com>
X-SW-Source: 2000-11/msg00203.html
Content-length: 502

When I try that, I get an error message:

Continuing.
RDI_execute: a miscellaneous type of error

Program received signal SIGTERM, Terminated.
?? () at setup.S:4
4 B Reset_Handler
Current language: auto; currently asm

using gdb 5.0 (insight w/ -nw) and 7211 eval board.

Any ideas?

On Mon, 20 Nov 2000 10:48:14 Fernando Nasser wrote:
> The sequence of commands you should use is:
>
> file <exec>
> target rdi e=....
> load
> break <somewhere>
> cont
>
>
> Don't use the load command argument.