gdb m68k remote debugging - unwanted program stop after 24 lines console output

[hollerer@gmx.net]

hi,

i have a little question which i hope you can answer.

host: linux, m68k-gdb-aout 4.18
target: motorola 68332, m68k-stub.c
remote debugging via rs232

i have wrapped the output of the target into a 'O' message.
this works fine. but the host gdb stops the program after
24 lines of output with the message:
 ---Type <return> to continue, or q <return> to quit--- 

can i avoid this? it's ok that the output would get lost.
but the program should not be stopped.

thx for any answer
franz hollerer

-- 
Austria
Usually we don't have kangaroos.
From msalter@cygnus.com Tue Apr 18 01:55:00 2000
From: Mark Salter <msalter@cygnus.com>
To: hollerer@gmx.net
Cc: gdb@sourceware.cygnus.com
Subject: Re: gdb m68k remote debugging - unwanted program stop after 24 lines console output
Date: Tue, 18 Apr 2000 01:55:00 -0000
Message-id: <200004180855.BAA06942@rtl.cygnus.com>
References: <38FC1F40.FB4B7D45@gmx.net>
X-SW-Source: 2000-04/msg00083.html
Content-length: 462

>>>>> hollerer  writes:

> hi,
> i have a little question which i hope you can answer.

> i have wrapped the output of the target into a 'O' message.
> this works fine. but the host gdb stops the program after
> 24 lines of output with the message:
>  ---Type <return> to continue, or q <return> to quit--- 

> can i avoid this? it's ok that the output would get lost.
> but the program should not be stopped.

Try "set height 0" in your .gdbinit file.

--Mark