Re: error building gcc , (simulators and targets...)

[msarasa@fh-konstanz.de]

Zitat von Daniel Jacobowitz <drow@mvista.com>:

> On Thu, Jan 16, 2003 at 03:18:15PM +0100, msarasa@fh-konstanz.de wrote:
> > Zitat von Daniel Jacobowitz <drow@mvista.com>:
> > 
> > > On Thu, Jan 16, 2003 at 01:55:02PM +0100, msarasa@fh-konstanz.de wrote:
> > > > I made four directories for building Binutils , GCC , Newlib and Gdb ,
> in
> > > this 
> > > > order.
> > > > They're called:
> > > > build-gcc
> > > > build-binutils
> > > > build-newlib
> > > > build-gdb
> > > > 
> > > > I made also a folder h8300-elf-gnu to install there.
> > > > 
> > > > Sources are contained in miguel/gnu
> > > > 
> > > > I made
> > > > cd build-newlib
> > > > ../gnu/binutils/configure --prefix=/h8300-elf-gnu --target=h8300-elf
> > > > 
> > > > There's no error message with this , but then I do 
> > > 
> > > Same problem.  Try
> > > 
> > >  ../gnu/configure --prefix=/h8300-elf-gnu --target=h8300-elf
> > > 
> > 
> > this wouldn't configure not only binutils but the whole gnu? I've made that
> , 
> > and seems like the configuration for all the stuff... 
> > Or , should I do this instead of one configure than one make for binutils ,
> 
> > that for gcc... Is this the way to configure and Install gnu in one step?
> 
> Yes, you configure everything at once.  Then you can just say "make".
> 
> -- 
> Daniel Jacobowitz
> MontaVista Software                         Debian GNU/Linux Developer
> 
I've just made that , but:
I didn't get an executable looking like h8300-elf-gdb
I ran gdb, but I still have no success with "target sim" command , even though 
this processor should have a built-in simulator.

Thanks again!